Flintec MCS-64 ModbusOnEthernet Bedienungsanleitung PDF herunterladen (Seite 11)

Manual MCS-64: Modbus on Ethernet

Page 11

2061 Int16 1 R/W Bit commands. Functions regardless of the setting of the LDM

selector register.

Bit 1: Reset Zero (RZ)

Bit 2: Set Zero (SZ)

Bit 3: Reset Tare (RT)

Bit 4: Set Tare (ST)

Bit 5 – 7: unused

Bit 8 –15: LDM#

Write a “1” to activate function, reads as “1” until command done

2062 Int16 1 R/W Trigger: Functions regardless of the setting of the LDM selector

Write the LDM number to trig LDM;

Write the LDM number + 80h(128 dec) to cancel measurements

(LDM 88.183 only)

2063 Int16 1 R/W Parameter page select. Valid values= [0..4].

General parameter values

Calibration parameter values

Filling parameter values

Check weigher parameter values

Mass flow parameter values

2064 Int16 1 R/W TAC access, see calibration page.

2065 Int16 1 R/W START / ABORT filling process.

Writing a Non-zero value starts filling process.

Writing a zero ABORTS filling process.

2066 Int16 1 R/W EEPROM functions:

Bit 1: Save analogue parameters (AS)

Bit 2: Save calibration (CS); TAC protected

Bit 3: Save general setup parameters (WP)

Bit 4: Save dosing parameters (SD)

Bit 5: Save setpoint parameters (SS)

Bit 6 –14: unused

Bit 15: Factory default; TAC protected

2067 Int16 1 R/W Set-point select [0..3]

2068 Int32 2 R/W Set-point source

206A Int32 2 R/W Set-point hysteresis

206C Int32 2 R/W Set-point Value

206E Int16 1 R Read the dose info:

Bit value Meaning

$0001 Coarse valve open

$0002 Fine valve open

$0004 Dose program running

$0008 Not used

$0010 Not used

$0020 Not used

$0040 Tare out of range – no filling in this cycle

$0080 Zero out of range

$FF00 The High byte has the following interpretation:

00= Idle

01= Waiting for trigger(2

trigger)

02= Bottle on, calculating tare

03= Pre-fill

04= Main Filling

05= Fine Filling

06= In-flight delay

07= Post fill calculations

08= Post Filling

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 44 45

Kommentare zu diesen Handbüchern

Keine Kommentare

Flintec MCS-64 ModbusOnEthernet Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Flintec MCS-64 ModbusOnEthernet