Flintec MCS-08 Bedienungsanleitung PDF herunterladen (Seite 15)

MCS-08 Technical Manual, Rev. 1.04 December 2012 Page 15 of 52

5.3. N-Bus Addressing

First define the number of MCS-08AD

modules and MCS-08IO modules in the

GSD configuration.

Figure 5.3 – xFace GSD configuration

Figure 5.4 – xFace N-bus Addressing Tab

Address: Addresses of the MCS-08AD modules

Read button: Reads the N-address and the serial number of the MCS-08AD module

Write button: Writes the N-address to the MCS-08AD module with the corresponding serial number

Auto Address: Fills the address fields with values 0 to 7

Address: Addresses of the MCS-08IO modules

Read button: Reads the N-address and the serial number of the MCS-08IO module

Write button: Writes the N-address to the MCS-08IO module with the corresponding serial number

Auto Address: Fills the address fields with values 0 to 7

For the first time connection to a MCS-08 system only the gateway and the addressing tabs become active.

First address the modules to the N-Bus to activate the modules within the MCS-08 system.

Addressing MCS-08AD modules to the N-Bus: First click the „Read‟ button to read the serial numbers and

the addresses. Then define an address for each MCS-08AD module within the system. Then click the „Write‟

button to save the address settings. If the addressing of the MCS-08AD modules to the N-Bus is successfully

completed, then the Setup, the Calibration and the Converter Status tabs as well as the Scale Address and the

Visual Weight Display will be activated.

Addressing Input/Output Instruments to N-Bus: First, click the „Read‟ button to read serial numbers and the

addresses. Then define an address for each MCS-08IO module within the system. Then click the „Write‟ button

to save the address settings. If the addressing of the MCS-08IO modules to the N-Bus is successfully

completed, then the I/O Status tab will be activated.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 51 52

Keine Kommentare

Flintec MCS-08 Bedienungsanleitung Seite 15